- 4th*1
- 1st to 6th*2
| Last Modified: 11-29-2007 | 1.6 D | |
| Service Category: Drivetrain | Section: Automatic Transmission/Transaxle | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000000W7C09EX |
| Title: AB60E AUTOMATIC TRANSMISSION / TRANSAXLE: AUTOMATIC TRANSMISSION SYSTEM: MANUAL SHIFTING TEST (2008 Sequoia) | ||
MANUAL SHIFTING TEST
1. MANUAL SHIFTING TEST
HINT:
- Through this test, it can be determined whether the trouble occurs in an electrical circuit or if it is a mechanical problem in the transmission.
- If any abnormalities are found in the following test, the problem is in the transmission itself.
|
(a) Disconnect the connector of the No. 1 transmission wire and/or No. 2 transmission wire. HINT:
It is possible to deactivate the electrical shift control by disconnecting the transmission wires. The gear positions can then be changed mechanically with the shift lever. |
(b) Drive the vehicle with the transmission wires disconnected. Move the shift lever to each position to check whether the gear position changes as shown in the table below.
|
Shift Lever Position |
Gear Position |
|---|---|
|
P |
P |
|
R |
R |
|
D |
|
HINT:
- *1: When disconnecting only the No. 1 transmission wire or the No. 1 and No. 2 transmission wires.
- *2: When disconnecting only the No. 2 transmission wire.
(c) Connect the connector of the No. 1 transmission wire and/or No. 2 transmission wire.
(d) Clear the DTC
.
|
|